Bosch WAXH2KL0SN, Руководство пользователя и инструкции по установке

Страница: 45 / 72

Home Connect
en
45
Connecting the appliance to
the energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts only
when your home photovoltaic system
can provide sufficient energy or the en-
ergy tariff is good.
Requirements
¡
The smart energy system (energy
manager) must use the EEBus Initiat-
ive communications standard.
¡
You have read about how to connect
your appliance to the smart energy
system (energy manager) in the in-
struction manual for the smart en-
ergy system (energy manager).
1.
Press and hold ⁠ for approx. 3
seconds.
a
The display shows
Aut
.
2.
Set the programme to position 7.
→
"Overview of Home Connect set-
tings", Page 40
a
The display shows
EnG
.
3.
Press ⁠ .
a
The appliance is connected to the
smart energy system (energy man-
ager).
a
If the appliance has connected to
the energy manager successfully,
the display shows and ⁠ .
4.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 45
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to provide
sufficient energy or the energy tariff is
good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
-
⁠
+
to set the required time.
3.
Press ⁠ .
4.
Press ⁠ .
a
The display shows ⁠ and Flex Start
is activated. The appliance waits to
be started by the smart energy sys-
tem (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy system
(energy manager) has established a
time at which your appliance can
start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends. The
programme ends when the time
period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡
Press ⁠ .
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
Remote diagnostics
Customer Service can use Remote Dia-
gnostics to access your appliance if
you contact them, have your appliance
connected to the Home Connect server
and if Remote Diagnostics is available
in the country in which you are using
the appliance.
Tip:
For further information and details
about the availability of Remote Dia-
gnostics in your country, please visit
the service/support section of your
local website: www.home-connect.com