en
Faults and what to do about them.
46
r
is flashing
The appliance is not being supplied with water:
■
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
Clean the filter if necessary.
E
3 sec. is continu-
ously lit
The childproof lock is activated – deactivate it.
E
3 sec. is flashing
The childproof lock is activated – the programme selector has been turned or the
control panel touched.
Û
is flashing
Run the
Drum Clean
Û
90 °C
programme or a 60 °C programme to clean and
care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use all-purpose washing powder or a detergent that contains a bleaching
agent. To prevent foaming, only use half the amount of detergent recom-
mended by the detergent manufacturer. Do not use detergents designed for
woollens or delicates.
■
Switch the notification signal on/off
Å
is continuously
lit
Too much foam has been detected; additional rinse cycles have been activated.
ù
is continuously lit Only for programmes with automatic dosing activated:
■
The detergent drawer has not been pushed in fully. Push the detergent drawer
in fully.
■
The pump unit is not inserted. Insert the pump unit into the drawer lid.
w
or
M
is flashing
There is not enough detergent/softener in the
w
or
M
dispenser. Add more deter-
gent/softener into the relevant dispenser.
E:10 alternating with
- 00, - 10 or - 20
The pump unit of the automatic dosing system is blocked. Switch off the appliance.
Clean the pump unit.
If this indicator/symbol/code appears again, call our after-sales service.
E:60 alternating with
- 2b and
End
at the end of the programme.
Not an appliance fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Run the spin cycle
again, if necessary.
E:35 alternating with
- 10
There is water in the base trough; the appliance is leaking. Turn off the water tap.
E:36 alternating with
- 10
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
Other indicators/sym-
bols/codes
Switch off the appliance, wait for 5 seconds and then switch it back on. If this indica-
tor/symbol/code appears again, call our after-sales service.
Display
Cause/remedy
