Operating the appliance
en
19
Childproof lock
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock after starting
the programme.
To
activate/deactivate
the childproof
lock, press and hold Start/Reload for
approx. five seconds. The
E
symbol
appears in the display panel.
■
E
lights up: The childproof lock is
active.
■
E
flashes: The childproof lock is
active and the programme selector
was adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme. The symbol
lights up again.
Note:
The childproof lock can remain
activated until you wish to start the next
programme, even after switching off the
machine.
You must then deactivate the childproof
lock before starting the programme and
activate it again as necessary once the
programme has started.
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/
Reload
A
button.
The Start/Reload
A
indicator lamp
flashes and the machine checks
whether it is possible to add laundry.
Note:
Do not leave the washing
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If the display panel shows:
■
Both
the
YES
and
¼
symbols lit up,
it is possible to add laundry.
■
A flashing
NO
symbol, wait until
YES
and
¼
light up.
Do not open the door until
both
the
YES
and the
¼
symbols are lit.
■
A flashing
NO
symbol, it is not
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the
Start
/Reload
A
button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Press Start/
Reload
A
.
2.
Select the other programme.
3.
Press Start/Reload
A
. The new
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
1.
Press Start/
Reload
A
2.
To cool the laundry: Select
O
Rinse
.
3.
Press
Start
/Reload
A
.
For programmes at low temperatures:
1.
Press Start/
Reload
A
.
2.
Select
0
Spin
or
[
Drain
.
3.
Press
Start
/Reload
A
.
Programme end during rinse
hold
– – –
0
appears on the display panel
and the Start/Reload button indicator
lamp flashes.
To end the programme, set the
programme selector to
0
Spin /
[
Drain or select a spin speed. Then
press the
Start
/Reload
A
button.
