Bosch WAE20167ZA Series, Инструкция по эксплуатации и монтажу

Страница: 21 / 36

Cleaning and maintenance
en
21
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When you wash at high temperatures,
the detergent solution gets very hot. If
you come into contact with the hot
detergent solution, you may be scalded.
Allow the detergent solution to cool
down.
1.
Turn off the water tap so that no
more water can flow in and has to be
drained via the detergent solution
pump.
2.
Switch off the appliance. Pull out the
mains plug.
3.
Open and remove the service flap.
4. For models with a drain hose:
Take the drain hose out of the
retainer.
Remove the sealing cap; allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drain hose in the retainer.
5. For models without a drain hose:
Carefully unscrew the pump cover
until the detergent solution begins to
flow out.
When the service flap is half full,
close the pump cover and drain the
service flap.
Repeat the above steps until all the
detergent solution has completely
drained out.
6.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
7.
Place the service flap back on, lock
it into place, and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment
II
and start the
Drain
programme.