Bosch WAE20067ES, Инструкция по эксплуатации и руководство по установке

Страница: 17 / 36

Positioning and connecting
en
17
■
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
■
Never unplug the mains plug during
operation.
Observe the following information and
ensure that:
Notes
■
The mains voltage and voltage
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The washing machine is only
connected to an alternating current
supply via a properly installed
earthed socket.
■
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
installed.
■
If the mains cable needs replacing,
only a qualified electrician may do it.
Replacement mains cables are
available from the after-sales service.
■
Do not use multiple plugs/couplings
or extension cables.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
z
symbol can be fitted.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
Do not bend, squash, modify, cut
through, or bring the mains cable
into contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly installed
and
connected
(from
~
Page 12 ).
■
Never use a damaged machine.
Inform the after-sales service.
~
Page 34
1.
Check the washing machine.
2.
Connect the mains plug.
3.
Turn on the tap.
4.
Switch on the appliance.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
Cottons 90 °C
programme.
7.
Open the detergent drawer.
8.
Pour approximately 1 litre of water
into compartment
II
.
9.
Add standard detergent to
compartment
II
according to
manufacturer’s instructions for light
soiling.
Note:
To prevent foaming, only use
half the recommended amount of
detergent. Do not use detergents
designed for woollens or delicates.
10.
Close the detergent drawer.
11.
Press the
Start button
.
12.
Switch off the appliance when the
programme has finished.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
3.
Drain the remaining detergent
solution.
4.
Disconnect the washing machine
from the mains.
5.
Remove the hoses.