7
Overview
of
programmes
a
Refer
to
the
table
of
consumption
values
on
page
8
and
notes
on
page
6.
Pr
ogr
ammes
°C
max.
Type of laundr
y
A
dditional functions; inf
or
mation
Cottons
20, 30, 40, 60, 90 °C
5.5
kg
3,5kg*
Hard-
wearing fabrics, heat-
resistant fabrics made
of cotton or linen
, Express Wash*
Cottons
(ECO
)
~
5.5 kg
E
asy-
C
ar
e
30, 40 °C
2.5 kg
Easy-
care fabrics made of cotton, linen, synthetic
fibres or blended fabrics
, Express Wash
Delicate
30 °C
2 kg
For delicate, washable fabrics, e.g. made of silk,
satin, synthetic fibres or blended fabrics (e.g. cur-
tains)
, Express Wash
No spin between rinse cycles
Wool
30 °C
Hand
ä
or machine-
washable fabrics made of wool
or containing wool
, Express Wash;
Particularly
gentle
wash
programme
to
prevent
shrinkage
of
laundry.
Longer programme breaks (fabrics rest in the detergent
solution)
Super Quick 30’
30 °C
3,5kg
Easy-
care fabrics made of cotton, linen, synthetic
fibres or blended fabrics
Short programme, approx. 30 minutes,
suitable for lightly soiled laundry
A
dditional programmes
Rinse, Spin, Drain
*
reduced load
wh
en
us
in
g th
e Expres
s Wa
sh
opti
on
.
Programmes without prewash - add detergent to compartment
II
, programmes with prewash - distribute the detergent betwe
en compartments
I
and
II
.
9310 / 9000939268
WAB24060GB
Robert Bosch Hausgeräte GmbH
Carl-
Wery-
Str. 34
81739 München
/ Germany
8
Safety instructions
– Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
– Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and risking their lives.
Danger of suffocation
– Keep packaging, film and packaging parts out of the reach of
children.
Risk of poisoning
– Keep detergents and care products out of the reach of children.
Risk of explosion
– Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover/cleaning solvent may cause an
explosion after being loaded into the washing machine.
Rinse items of laundry thoroughly by hand beforehand.
Risk of injury
– The washing machine door can become very hot.
– Be careful when draining hot detergent solution.
– Do not climb onto the washing machine.
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine
is in operation.
Consumption values
Programme
Load
Energy
***
Water
***
Programme duration (h)
***
Cottons 20 °C
5.5 kg
0.25 kWh
57 l
1 3/4 h
Cottons 30 °C
5.5 kg
0.40 kWh
57 l
1 3/4 h
Cottons 40 °C*
5.5 kg
0.75 kWh
57 l
1 3/4 h
Cottons 60 °C
5.5 kg
1.20kWh
57 l
2 h
Cottons 90 °C
5.5 kg
2.00 kWh
64 l
2 h
Easy-Care 40 °C*
2.5 kg
0.60 kWh
50 l
1 1/2 h
Delicate 30 °C
2 kg
0.30 kWh
55 l
1 h
Wool 30 °C
2 kg
0.20 kWh
30 l
1 h
*Programme setting for testing in accordance with currently applicable EN60456 standard.
Note on comparative tests: When testing the test programmes, wash the specified load using the maximum spin speed.
Programme
Load
Annual energy consumption Annual water consumption
Cottons
~
(
Eco)
**
5,5/2,75 kg
182 kWh
8800 l
**
Programme settings for testing and energy labelling in accordance with EU directive
2010/30/EU with cold water(15 °C).
*** The values may deviate from the specified values depending on water pressure, water hardness, and inlet temperature,
ambient temperature, type, amount and level of laundry soiling, detergent used, fluctuations in the power supply and selec-
tion of options.
The programme used for the evaluation of the captioned model under the Mandatory Water Efficiency Labelling Scheme
(MWELS) in Singapore is as follow: Cottons 60°C + (Eco)
8
9
Before washing for the first time
Do not load any laundry into the machine. Turn on the tap. Add the following to compartment
II
:
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
Set the programme selector to
Cottons 60 °C
and select
Start
. At the end of the programme,
turn the programme selector to
Off
.
Care
Machine housing, control panel
– Remove detergent residue immediately.
– Wipe off with a soft, damp cloth.
– Do not clean with a jet of water.
Cleaning the detergent drawer ...
... if it contains detergent or fabric softener residues.
1.
Pull out, press insert down, remove drawer completely.
2.
To remove the insert: press the insert upwards from below with your
finger.
3.
Clean the detergent dispenser tray and insert with water and a brush and
dry it.
4.
Attach the insert and engage (connect the cylinder to the guide pin).
5.
Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
Drum
Leave the washing machine door open so that the drum can dry out.
Rust stains - use chlorine-free cleaning agent, not steel wool.
Descaling
Ensure there is no laundry in the machine
This should not be necessary if the correct detergent dosage has been used. If it is necessary, however,
proceed according to the descaling agent manufacturer's instructions. Suitable descalers can be obtained via
our website or from our after-sales service (
a
page 1
).
Information to indicator lights
Indicator lights for status displays flash:
Wash
and
Rinse
Close the washing machine door properly; laundry may be caught.
Wash
and
Spin
– Open the tap completely.
– Supply hose kinked or trapped.
– Clean the filter
a
page 10
, Water pressure too low.
Rinse
and
Spin
Detergent solution pump blocked; Clean the detergent solution pump
a
page 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon
a
page 10
.
–
Risk of electric shock.
Disconnect the mains plug.
–
Risk of explosion.
No solvents.
10
Maintenance
Detergent solution pump
Turn the programme selector to
Off
and disconnect the mains plug.
1.
Remove the service flap for detergent solution pump.
2.
Carefully unscrew the pump cover (residual water).
3.
Clean the interior, pump cover thread and pump housing (the impeller in
the detergent solution pump must rotate).
4.
Replace the pump cover and screw it tightly.
5.
Place the service flap back.
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment
II
and start the
Drain
programme.
Drainage hose at the siphon
Turn the programme selector to
Off
and disconnect the mains plug.
1.
Loosen the hose clamp, carefully remove the drainage hose
(residual water).
2.
Clean the drainage hose and siphon connecting piece.
3.
Reattach the drainage hose and secure the connection with the hose
clamp.
Filter in the water supply
Risk of electric shock
Do not immerse the HydroSafe safety device in water (contains an electric valve).
Reduce the water pressure in the supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Spin
c
/ Drain
).
3.
Select
Start
. Let the programme run for approximately 40 seconds.
4.
Turn the programme selector to
Off
. Disconnect the mains plug.
5.
Clean the filter:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or
for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
6.
Connect the hose and check the leak tightness of the
connection points.
–
Risk of scalding.
Allow the
detergent solution to cool down.
– Turn off the tap.
11
What to do if ...
ʑ
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
ʑ
No water supply.
Detergent not dispensed.
–
Start
not selected?
– Tap not turned on?
– Filter blocked? Clean the filter
a
page 10.
– Supply hose kinked or trapped?
ʑ
Washing machine door
cannot be opened.
– Safety function active. Wait approx. 2 minutes.
ʑ
Programme does not
start.
–
Start
selected?
– Washing machine door closed?
ʑ
Detergent solution is not
drained.
– Clean the detergent solution pump
a
page 10.
– Clean the waste pipe and/or drainage hose.
ʑ
Water not visible in the
drum.
– Not a fault - water below the visible area.
ʑ
Unsatisfactory spin
result.
Laundry wet/too damp.
– Not a fault - the unbalanced-load detection system has cancelled
the spin cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the
drum.
– Selected speed too low?
–> page 5.
ʑ
Spin cycle performed
several times.
– Not a fault - unbalanced load detection system adjusts the
imbalance.
ʑ
Residual water in the
compartment
~c
for care
products.
– Not a fault - the action of the care product is not affected.
– Clean the insert if necessary
–> page 9
.
ʑ
Odour formation in the
washing machine.
– Run programme
Cottons 90 °C
without laundry. Use standard
detergent.
ʑ
Foam escaping from the
detergent drawer.
– Too much detergent used?
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment
II
(not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation,
vibrations and
“wandering” during the
spin cycle.
– Are the appliance feet fixed?
Secure the appliance feet
a
Installation instructions
.
– Transportation safety devices removed?
Remove the transportation safety devices
a
Installation
instructions
.
ʑ
Indicator lamps do not
function during
operation.
– Power cut?
– Fuses triggered? Reset/change the fuses.
– If the fault occurs repeatedly, call the after-sales service.
ʑ
Programme sequence
longer than usual.
– Not a fault - unbalanced load detection system adjusts
imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
ʑ
Detergent residues on
the laundry.
– Occasionally, phosphate-free detergents contain water-insoluble
residues.
– Select
Rinse
or brush the laundry after washing.
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to
Off
and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
a
Installation instructions.
en
operating instructions
Washing machine
WAB24060GB
www.devicemanuals.eu/
