Bosch VOT-320, Инструкция по установке и эксплуатации

Страница: 78 / 116

78 en | Configuration using a Web browser VOT-320
DOC | V4.5 | 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH
In this way, a VOT-320 can be serviced and updated remotely without a technician having to
change the installation on site.
You obtain the current firmware from your customer service or from the download area at
www.boschsecurity.com.
1. First store the firmware file on your hard drive.
2. Enter the full path of the firmware file in the field or click Browse to locate and select the
file.
3. Next, click Upload to begin transferring the file to the camera. The progress bar allows
you to monitor the transfer.
The new firmware is unpacked and the Flash EPROM is reprogrammed. The time remaining is
shown in the message going to reset Reconnecting in ... seconds . The camera reboots
automatically once the upload has successfully completed.
If the CONNECT LED then flashes red, the upload has failed and must be repeated. To
perform the upload you must now switch to a special page:
1. In the address bar of your browser, enter /main.htm after the IP address of the VOT-320
(for example 192.168.0.10/main.htm ).
2. Repeat the upload.
Configuration
You can save configuration data for the VOT-320 on a computer and then load saved
configuration data from a computer to the camera.
Upload
1. Enter the full path of the file to upload or click Browse to select the required file.
2. Make certain that the file to be loaded comes from the same camera type as the camera
you want to configure.
3. Next, click Upload to begin transferring the file to the camera. The progress bar allows
you to monitor the transfer.
Once the upload is complete, the new configuration is activated. The time remaining is shown
in the message going to reset Reconnecting in ... seconds . The camera reboots automatically
once the upload has successfully completed.
Download
1. Click the Download button. A dialog box opens.
2. Follow the on-screen instructions to save the current settings.
CAUTION!
Before launching the firmware upload make sure that you have selected the correct upload
file. Uploading the wrong files can result in the camera no longer being addressable, in which
case you must replace the camera.
You should never interrupt the installation of firmware. An interruption can lead to the flash-
EPROM being incorrectly programmed. This in turn can result in the camera no longer being
addressable, in which case it will have to be replaced. Even changing to another page or
closing the browser window leads to an interruption.