6 000 836 999
2013-05-08
|
Bosch Automotive Diagnostics Equipment (Shenzhen) Limited
Operation|��������|1�
��������|1�
|1�
en
6.
Operation
6.1
Importantnotesonoperation
¶
The lifting platform is only to be operated by author-
ized, qualified personnel of at least 18 years of age.
¶
The passenger vehicles or motor vehicles to be lifted
must not have a maximum gross weight of more than
3,500 kg.
¶
With maximum load, the load distribution should be
no more than 3:2, i.e. the load on one pair of sup-
port arms should not exceed 2,100 kg.
¶
Certain special-purpose vehicles are not to be raised
using 2-post lifting platforms. Before lifting, check
that the vehicle is not a special-purpose vehicle.
¶
only raise the vehicle at the four jacking points speci-
fied by the vehicle manufacturer.
¶
Only ever operate the lifting platform by way of the
operating unit provided.
¶
Before moving the lifting platform, make sure there
is no-one in the hazard zone and that there are no
objects leaning against or positioned on the vehicle
or lifting platform.
¶
Access to the lifting platform area must not be
granted to non-authorized personnel.
¶
The carrying of persons on the lifting platform or in
the vehicle is prohibited.
¶
Never use the lifting platform as a crane or support
for other lifting mechanisms (e.g. block and tackle).
¶
Electric welding work is only to be performed on the
raised vehicle or on the lifting platform itself if the
main switch is set to OFF (O).
¶
Never use the lifting platform in the event of mal-
functioning or component damage.
¶
In the event of problems, the lifting platform is to
be immediately shut down and secured against
unauthorized use and Bosch customer service or an
authorized service agent must be informed.
¶
Lock the main switch when not in use.
6.�
Switch-on
Switch on the VLH 2235H by way of the main switch.
¶
Set the main switch to the ON (I) position.
"
Lifting platform is ready for operation.
6.�
Preparation
1.
Fully lower the support arms.
2.
Swivel the support arms to the maximum through-
width.
3.
Remove any tools, dirt, grease and oil from the vicin-
ity of the lifting platform.
4.
Remove any grease and oil from the mounts.
6.4
�ehiclepositioning
DANGER–Riskofincorrectvehicleposition-
ing!
Risk of (fatal) injury due to the vehicle falling
or tipping up during lifting, when working on
the vehicle and on lowering.
¶
Position the vehicle exactly as described.
1.
Make sure the support arms are fully lowered and
swiveled to the maximum clear width.
2.
Drive the vehicle into position between the posts
such that it is straight and centered.
!
Heed the direction of travel. The operating unit must
be on the right lifting post when viewed in the direc-
tion of travel.
3.
Drive the vehicle forward until its center of gravity is
on a level with the posts.
i
On many vehicles the center of gravity is roughly on
a level with the front door hinges.
4.
Carefully open the door and get out of the vehicle.
!
Take care not to bang the vehicle door against the
post.
5.
Check the jacking points specified by the vehicle
manufacturer for stability and corrosion.
6.
Swivel the support arms under the vehicle and posi-
tion the mounts under the four jacking points.
7.
Turn the mounts until they are in full contact with
the jacking points.
!
Never turn the mounts beyond the stop. The remain-
ing thread length would not guarantee firm support.
"
Vehicle positioned on lifting platform.
