22
en | Installing the Monitor
Bosch High Performance HD LED Monitors
F.01U.134.499 | 2.0 | 2012.10
User's Manual
Bosch Security Systems, Inc.
Figure 5.2
UML-423-90 - Location of mounting holes
Figure 5.3
UML-553-90 - Location of mounting holes
5.4
Connecting Power
The Bosch Flat Panel CCTV monitors are delivered with a 3-pole US-style power cord and a 3-
pole Euro-style power cord. Use the US-style power cord where 120 VAC, 60 Hz power is
available; use the Euro-style power cord where 230 VAC, 50 Hz power is available. The
monitor automatically adjusts to either power input voltage.
5.5
Connecting the Composite Video Signal to the Monitor
There is one (1) BNC connector located on the rear panel of the monitor for composite video
input and one (1) BNC connector for composite video output (Refer to
Section 3.2 Rear
Panels, page 14
).
Note:
All video inputs are passive loop-through. The impedance is automatically set to 75 ohm
by the input of the signal on the input connector, while operating in a single connection mode
(refer to
Figure 5.9
). If a cable is also connected to the output connector, the video signal can
be passed on to another monitor connected to it via the passive loop-through function. Up to
three (3) monitors may be connected in this manner (refer to
Figure 5.10
).
Note:
To select AV1, press VIDEO SOURCE/ENTER, and then press the Up or Down arrow
button, located on the front of the monitor.
400 mm
400 mm
400 mm
400 mm
Содержание UML-323-90
Страница 1: ...Bosch High Performance HD LED Moni tors UML 323 90 UML 423 90 UML 553 90 en User s Manual ...
Страница 2: ......
Страница 40: ......
