Bosch TES?712 Series, Инструкция по эксплуатации

Страница: 21 / 172

17
TES7.. | 08/2013
en
Preparing milk froth and
warm milk
¡
Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe
10d
of the milk
frother 10 deep in the milk container 26 .
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10 .
● Select the required setting
Milk froth
È
or
Warm milk
É
by turning the rotary
knob 6 .
● Press the start button 8 .
Milk froth or warm milk flows from the outlet
of the milk frother
10
.
Press the
start
button
8
again to cut the
process short.
Info: When preparing warm milk, you may
hear a whistling sound. This is caused by
the milk frother 10 for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important:
Dried milk residue is difficult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see “Cleaning the milk system”).
Dispensing hot water
¡
Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The milk frother must be cleaned before
drawing hot water.
The appliance must be ready for use.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10 .
● Select the required setting for
Hot
water
Ê
by turning the rotary knob 6 .
● Press the start button 8 .
Please remove suction hose

start
● Remove the milk suction hose 10c and
press the
start
button
8
.
Hot water runs out of the milk frother
outlet
10
.
Press the start button 8 again to cut the
process short.
Note: It is possible to set the temperature of
the hot water (see “Menu settings”).