Bosch TCC78K751, Инструкция по эксплуатации

Страница: 51 / 102

English | 49
Bosch TCC78K751 | 02/2014
– Calc‘n‘Clean : If you want to descale
and clean the appliance at the same
time, press
o
start/stop (10) and run
the Calc‘n‘Clean programme (see
“Calc‘n‘Clean”).
– Water hardness : Press the arrow button
p
. Turn the knob to select the re-
quired water hardness (1, 2, 3 or 4) (refer
also to “Checking and setting the water
hardness”).
– Coffee temperature : Press the arrow
button
p
. Turn the knob to set the coffee
temperature.
– Auto off after : Press the arrow button
p
.
Turn the rotary knob to enter the time
span after which the appliance should
automatically switch off following the
last drink preparation. A time between
5 minutes and 8 hours can be set. The
default time is 30 minutes, but this can
be shortened to save energy.
– Illumination : Press the arrow button
p
.
The lighting can be set to
Off
,
On
(factory
setting) or Off after 5 min .
– Tone : Press the arrow button
p
. The
audible signal you hear when a button is
pressed can be switched OFF or ON by
turning the rotary knob .
– Contrast : Press the arrow button
p
. The
display contrast can be set from –20 to
+20 with the rotary knob . The default
setting is 0.
–
Water filter
: Each time a new water filter is
inserted in the water tank (14), it must be
rinsed:
1. Place the water filter in the water tank
(14) and fill the tank with water up to
the “max” mark.
2. Press the arrow button
p
[ Start with
O
]
and press
o
start/stop (10).
3. Place a container with a capacity of 0.5
litres under the milk frother (12).
4. Press
o
start/stop (10). Water will now
run first through the filter to rinse it and
then into the container.
Empty the container. The appliance is
ready to use once more.
Rinsing the filter simultaneously activates
the setting for the Service - change filter
display.
The filter is no longer effective when the
Service - change filter display appears,
or at the latest after two months. It needs
to be replaced for reasons of hygiene and
so that there is no build-up of limescale
(this could damage the appliance).
Replacement filters can be obtained
from retailers or customer service (see
“Accessories”).
After every filter change the filter must first
be rinsed. Proceed as described at the
beginning of this section.
If no new filter is used, turn the water filter
setting to Off .
You can find detailed information
about the water filter in the en-
closed filter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should be
rinsed before the appliance is used
again. To do this, simply dispense a
cup of hot water.
– factory settings : You can cancel your own
settings and reset the factory settings. To
activate the factory settings, press
o
start/
stop (10).