Bosch TCA 54 SERIES, Руководство по эксплуатации

Страница: 19 / 93

15
Preparing hot water
The appliance must be ready for use. This
function allows water to be heated for a cup
of tea, for example.

!
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
● Place an appropriate cup under the
nozzle 9 .
● Push the sleeve on the nozzle
9 all the
way down .
● Turn the dial
8 to
g
/
h
.

!
Risk of scalding
When the dial 8 is set to
g
/
h
, the nozzle
may sputter a little. Do not touch the nozzle
9 or aim it at anyone.
● End the process by turning the dial
8
back to O.
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.

!
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
● Push the sleeve on the nozzle
9 all the
way down .
● Fill the cup approximately 1/3 full of milk.
● Press the
h
button. It will start to flash.
i
The appliance will heat up for approx. 20
seconds.
● Immerse the nozzle
9 deep into the milk,
but do not let it touch the bottom of the
cup.
● When the
h
button lights up and
8
appears on the display, turn the dial 8 to
g
/
h
.

!
Risk of scalding
When the dial 8 is set to
g
/
h
, the nozzle
9 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 9 or aim it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial
8
back to O.
Note: When the nozzle 9 has cooled
down, clean it immediately. Dried residue is
difficult to remove.
Tip: If possible, use cold low­fat (1.5% fat)
milk.
Steam for heating drinks

!
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
The appliance must be ready for use.
● Push the sleeve on the nozzle
9 all the
way up .
● Press the
h
button. It will start to flash.
i
The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle
9 deep into the liquid
you want to heat.
● When the
h
button lights up and
8
appears on the display, turn dial 8 to
g
/
h
.

!
Risk of scalding
When the dial 8 is set to
g
/
h
, the nozzle
9 may sputter a little. Escaping steam is
very hot and may cause liquid to sputter.
Do not touch the nozzle 9 or aim it at
anyone.
● End the process by turning the dial
8
back to O.
Note: When the nozzle 9 has cooled down,
clean immediately. Dried residue is difficult
to remove.
en
Downloaded from CoffeeMachineManual.com Manuals