17
01/2013
en
Troubleshooting
The following table provides solutions for problems and glitches that may arise as you
use your TASSIMO machine. If you do not find a solution for your specific problem, or the
problem persists after troubleshooting please contact our customer service department.
Problem
Possible!cause
Solution
Appliance not working;
no symbols light up.
There is no power supply.
Check that the appliance is
properly plugged into the
power supply.
I can’t read the LC-
display because it is in
the wrong language.
You may want to change the
language setting.
Please proceed as described
in the section “Controls and
displays”.
Machine brews but no
drink dispensed.
The water tank was removed
during the brewing process or
there is air in the system.
Replace the water tank in the
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
The float in the water tank is
stuck.
Clean the water tank and
ensure the float can move.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
Appliance is not switched on.
Make sure the appliance is
switched on before inserting a
T DISC.
No T DISC inserted.
Check if T DISC has been
inserted.
The barcode could not be
detected.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline.
O
Automatic mode
skipped, appliance
goes straight to
N
Manual mode.
The barcode could not be
detected.
Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start /stop
button.
03_TAS65-85_GB-CH.indb 17
11.01.2013 15:58:47
