7
PREPARING SAW MOUNTING BRACKETS
For GCM12SD, CM12SD, CM12, CM10GD, CM8S
Miter Saws:
See Figure 4.
1.Place a Long-Slot Sliding Mounting Plate
(1)
onto two
of the M8 x 26 mm carriage bolts and feed them into
the front of the mounting bracket as shown in figure
4.
2.Place a Short-Slot Sliding Mounting Plate
(2)
onto
two of the M8 x 26 mm carriage bolts and feed them
into the rear of the mounting bracket as shown in
figure 4.
For 5412(L), 4212(L), and 3912 Miter Saws:
See Figure 4.
1.Place a Long-Slot Sliding Mounting Plate
(1)
onto two
of the M8 x 44 mm carriage bolts and feed them into
the front of the mounting bracket as shown in figure
4.
2.Place a Short-Slot Sliding Mounting Plate
(2)
onto
two of the M8 x 44 mm carriage bolts and feed them
into the rear of the mounting bracket as shown in
figure 4.
For 4410(L) and 4405 Miter Saws:
See Figure 4 & 5.
1.Place a Long-Slot Sliding Mounting Plate
(1)
onto
each of the M8 x 26 mm carriage bolts and feed them
into the front of the mounting bracket as shown in
figure 4.
2.Before sliding the mounting plate all the way forward,
thread a Bolt Retainer
(3)
onto each bolt as shown in
figure 5. When threaded completely, this will prevent
the shorter bolt from falling below the top surface of
the tool mount.
3.Place a Short-Slot Sliding Mounting Plate
(2)
onto
two of the M8 x 44 mm carriage bolts and feed them
into the rear of the mounting bracket as shown in
figure 4.
Note:
The Long-Slot Sliding Mounting Plate will align
with the horizontal slot at the front of the mounting
bracket to accommodate Bosch miter saws with offset
mounting holes (5412(L), 4410(L) and 4212(L)).
Assembly
FIG. 5
3
M8 x 26 mm
[4410(L) & 4405
miter saws]
FIG. 4
M8 x 44 mm
[5412(L), 4212(L),
and 3912 miter
saws]
M8 x 44 mm
[5412(L), 4212(L),
4410(L), 4405, and
3912 miter saws]
M8 x 26 mm
[GCM12SD,
CM12SD, CM12
CM10GD, CM8S
miter saws]
M8 x 26 mm
[GCM12SD,
CM12SD, CM12,
CM10GD,
CM8S4410(L) and
4405 miter saws]
1
2
2610001768_T1B 8/17/17 8:57 AM Page 7
