Bosch SPV40C00GB, Руководство по эксплуатации

Страница: 6 / 28

en
6
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above a specific degree of
water hardness must be softened, i.e.
descaled, for use in a dishwasher. Water is
softened with special salt in the water
softening system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be set
in 4 stages depending on the hardness of
your water. Accordingly 0, 1, 2 or 3
displays are lit (see table). Factory setting:
1.
– Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
– Setting can be found in the water
hardness table.
– Open the door.
– Switch on ON/OFF switch
(
.
– Hold down button >
P
and press
START button
h
until the End display
`
and salt refill indicator
)*
flash.
– Release buttons.
The salt refill indicator
)*
flashes and
the display
#
is lit (= Setting 1).
To change the setting,
– Press the button <
H
until the
required setting has been selected.
– Press START button
h
.
The displays
`
and
)*
go out. The
selected setting is saved.
– Close the door.
Water hardness table
Water softening system
$ % &
ƒ&ODUNH
VRIW
PHGLXP
KDUG
KDUG
PPROO +DUGQHVV
UDQJH
6HWWLQJ