Bosch SPE53U5 UC Series, Руководство по эксплуатации

Страница: 17 / 50

15
Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the “
A
” button (see page 14) and press
[Start/Resume]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “ A ” button until the display shows “ r:04 ”.
5
Press the “ C ” button to select the desired setting.
“ r:00 ” = dispenser is OFF
“ r:01 ” = lowest setting
“ r:02 ” = low setting
“ r:03 ” = medium setting
“ r:04 ” = medium/high setting
“ r:05 ” = high setting
“ r:06 ” = highest setting
6
Press [Start/Resume] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to “ h:01 ”.
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start/Resume] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until “h:00” is indicated on the digital display.
2
Press and hold [Start/Resume] for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the dishwasher door remains open for more than 4
seconds after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again
and close the dishwasher door.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the
“A”
button (see page 14) and press
[Start/Resume]
until the display indicates
“H:0x”
(x can be any number).
3
Release both buttons.
4
Press the “A” button until the display indicates “P:0x” .
5
Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6
Press [Start/Resume] to save the setting.
Aquastop® Leak Protection
Our AquaStop® system contains leaks through a precisely engineered tub and sensor system that works
with our solid molded base. If a leak has occurred, it shuts down operation and automatically pumps out
water to avoid contact with the floor. It works 24/7 and can turn itself on.