Troubleshooting
en
45
Fault
Cause and troubleshooting
Excessive formation of
foam occurs.
▶
Change the brand of detergent.
Fault
Cause and troubleshooting
Special salt refill indic-
ator lights up.
Insufficient special salt.
▶
Add Special salt →
Sensor does not detect special salt tablets.
▶
Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up.
Water softening system is switched off.
▶
Setting the water softening system →
Refill indicator for
rinse aid lights up.
Insufficient rinse aid.
1.
Add Rinse aid →
.
2.
Set the amount of rinse aid to be dispensed.
Refill indicator for
rinse aid does not
light up.
Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 25
"Setting the amount of rinse aid", Page 25
Fault
Cause and troubleshooting
Water is left in the ap-
pliance at the end of
the programme.
Filter system or area under the filters is blocked.
1.
.
2.
.
Programme has not yet ended.
▶
Wait until the programme ends or cancel the pro-
gramme with
Reset
.
▶
"Terminate programme", Page 31
Appliance cannot be
switched on or oper-
ated.
Appliance functions have failed.
1.
Pull out the mains plug or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power supply.
4.
Switch the appliance on.
Appliance does not
start.
The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted.
1.
Check whether the socket works.
2.
Check whether the mains cable is properly inserted
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
▶
Close the appliance door.