Troubleshooting
en
37
Fault
Cause and troubleshooting
Cutlery is not dry.
Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
1.
Arrange cutlery individually where possible.
→
2.
Avoid points of contact.
Appliance interior still
wet after wash cycle.
Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Remnants of food on
tableware.
Tableware is placed too close together or basket is
overfilled.
1.
Arrange tableware with sufficient space in between.
The spray jets must reach the surfaces of the table-
ware.
2.
Avoid points of contact.
Spray arm rotation is blocked.
▶
Arrange tableware so that it does not obstruct
spray arm rotation.
Spray arm nozzles are blocked.
▶
Clean the Spray arms.
Filters are soiled.
▶
Clean the filters.
→
Filters are inserted incorrectly and/or not engaged.
1.
Insert the filters properly.
→
2.
Engage the filters.
Washing programme selected too weak.
▶
Select a more intensive washing programme.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food and do not
prerinse tableware.
Tall narrow receptacles in corner areas are not rinsed
adequately.
▶
Do not position tall narrow receptacles at too great
an angle or in corner areas.