Rinse aid
en
11
1.
Open the screw-type cap of the
compartment
12
.
2.
Fill the tank with water (only required
when switching on the appliance for
the first time).
3.
Then add dishwasher salt
(not table
salt or tablets)
.
The water is displaced and runs out.
As soon as the salt refill indicator
X
on the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
component
Detergents with salt component
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
special salt must be used.
Switching off salt refill
indicator/water softening
system
Switching off water softening system
If the salt refill indicator
X
is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
ヽ
Proceed as described under
“Adjusting the water softening
system” and set the value to
•
:
‹‹
.
The water softening system and salt
refill indicator are now switched off.
m
Caution
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
,
Rinse aid
R
i
n
s
e
a
i
d
As soon as the rinse-aid refill
indicator
`
is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
