en-us
Operating the Dishwasher
38
Operating the touch buttons
Buttons are sensitive and should be
touched gently. Avoid any grease or
food particles resting on the buttons
as they could activate the
dishwasher.
Wiping and cleaning can also
activate the dishwasher. For best
results, use bare, clean hands when
touching the buttons.
To clean the touch buttons wipe them
with a dry or slightly damp cloth.
Changing the settings
The dishwasher has been preset with
certain settings for your convenience.
You can change these factory
settings.
Change the setting as follows:
1.
Open the door.
2.
Switch on On/Off button
(
.
3.
Press Info button
8
for
3 seconds until the following text
is indicated in the digital display
@
:
Scroll with
< >
Set with - +
Leave with Setup 3 sec.
4.
Keep pressing button
>
)*
until
the required setting is indicated in
the display window at the top
@
.
5.
Make the selection with setting
buttons
+ -
X
.
6.
Press and hold the Info button
8
for 3 seconds.
The chosen setting has now been
stored.
Tip:
If you change several settings,
first make all changes in succession.
Now press the Info button
8
for
3 seconds. This saves all set values
in the appliance.
AquaSensor
AquaSensor
The AquaSensor is an optical
measuring device which measures
the cleanliness of the rinse water.
The AquaSensor is used according
to the wash cycle. If the AquaSensor
is active, “clean” rinse water can be
transferred to the next rinse and
water consumption can be reduced
by 0.8–1-5 gal (3–6 liters). If the
rinse water is not yet clear, the water
is drained and is replaced with fresh
water. In the automatic wash cycles
the temperature and running time
can also be adjusted to the degree of
soiling.
Time display
The wash cycle time is determined
during the wash cycle by the water
temperature, the amount of dishes,
as well as the degree of soiling and
may vary (depending on the selected
wash cycle). You can change the
time display into time of day or
hours/minutes so that the remaining
cycle time of the wash cycle appears
in the display window “Finish at” (for
example 15:20 o’clock) or “Finish in”
(for example 3:25 hours).