Rinse Aid
en-us
15
Adding rinse aid
NOTICE
To avoid oversudsing or clogging, do
not overfill the rinse aid
dispenser
9*
. Wipe up any spills
with a damp cloth.
1.
Open the rinse aid dispenser
9*
by pressing on the latch of the lid
and pull it open.
2.
Add liquid rinse aid to the
dispenser
9*
until it is full. Do
not overfill. Avoid spilling into air
vent hole.
3.
Close the lid. Lid must be fully
closed until it clicks in order to
seal.
4.
Wipe up any excess rinse aid that
may have puddled when the
dispenser reservoir is full.
The indicator light will go out a few
moments after the dishwasher door
is shut.
Tip:
For easier pouring, remove lid
from the rinse aid bottle.
NOTICE
Do not fill the rinse aid dispenser
9*
with detergent. Doing so will damage
the dishwasher.
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from
§
:
‹‹
to
§
:
‹‡
. The
factory setting is
§
:
ܠ
.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
1.
Press the
On/Off
button
(
.
2.
Hold down the function key
#
and press the
Start
button
P
until the display
8
indicates
•
:
‹
x or
š
:
‹
x (x can be any
number). Release both buttons.
3.
Press the function key
#
until
the display
8
shows
§
:
ܠ
.
4.
Press the function key
3
to
select the desired setting.
5.
Press the
Start
button
P
to
save the setting.
PD[
WFOU
BJS
Setting
Amount
§
:
‹‹
dispenser is OFF
§
:
‹‚
lowest setting
§
:
‹ƒ
low setting
§
:
‹„
medium setting
§
:
‹…
medium/high setting
§
:
ܠ
high setting
§
:
‹‡
highest setting