Bosch Sensortec
"
|
Application Board 3.0 User Guide
13 | 22
Modifications reserved | Data subject to change without notice
Document number: BST-DHW-AN008-00
Stabilization (OIS) interface or
Auxiliary I2C interface.
(7) GPIO3/INT2 Assigned depending on Shuttle design.
Typically reserved for Interrupt 2.
(7) GPIO6/OSDO Assigned depending on Shuttle
design. Typically reserved as the
sensor Data-out for the Optical
Image Stabilization (OIS) interface.
(8) GPIO7/ASDx
Assigned depending on Shuttle
design. Typically reserved as the
Data-in for the Optical Image
Stabilization (OIS) interface or Data
for the Auxiliary I2C interface.
(9) PROM-RW
This pin is used to connect to the 1-
Wire EEPROM to identify the
Shuttle Board 3.0 connected.
