Bosch Rexroth PST 6 0 Series, Руководство по эксплуатации

Страница: 263 / 330

1070080029 / 05 Bosch Rexroth AG Electric Drives
and Controls
PST 6xx0 | | 263 /330
Assembly
Table18: Rating of noise suppression equipment
Resistor Capacitor Diode
24 V
DC
48 V
DC
110 V
AC
220 V
AC
440 V
AC
-
-
220 Ohm / 1 W
220 Ohm / 5 W
220 Ohm / 5 W
-
-
0.5 uF 400/600 V
0.1 uF 500 V
0.1 uF 1000 V
1 N 5060/ZL 12
1 N 5060/ZL 22
7.2.2 Line connection
" Please note the following prescriptions in the context of electrical
connection:
• Operation of the thyristor power units is only intended for use in
buildings/property with an operating current greater than/equal to
100A for each phase.
• Operation of the thyristor power units at asymmetrical systems
(one system phase grounded) is not admissible.
• The thyristor power units may only be connected to earthed sys­
tems such as TT or TN systems.
In the case of non­earthed systems (e.g. IT system), an isolating
transformer with secondary earthed center has to be used.
One­sided earthing is not permitted.
• The mains system must be appropriately fused.
• If you use residual current protective equipment, it must be suita­
ble for being operated in your application!
Check the applicable manufacturer data!
Comply with all applicable regulations!
• Make sure that the mains voltage is within the permitted range.
For information on the permissible range, refer to section 15 from
page 309 and the nameplate of the respective thyristor power
unit.
The positions of the connections are indicated in Section 7.1.1 from
page 256.
"
Connect the PE connector at the thyristor power unit to a suitable
grounding point.
"
Connect terminal U1 at the thyristor power unit with system phase
L1.
"
Connect terminal V1 at the thyristor power unit with system phase
L2.
ENGLISH