Function 19/54
3 842 358 814/2017-01, MIT: LU 2,
Bosch Rexroth AG
• The input is executed with the supply voltage disconnected.
The power supply for the electronics comes from an integrated backup battery.
• The oil container LC 250 must be installed on the drive prior to the setting
(see page 31).
In the as delivered condition the display is on the left.
1.
press and hold the
SET
button (> 5 s), until the modes
TIME
and
PULSE
fl ash in the display.
2.
Press
2x
the
SET
button.
The display switches to the
PULSE
mode (PULSE fl ashes).
After about 3 seconds, the display switches to the selection of the oil container.
3.
Press SET button 1x
¨
LC60
Press SET button 2x
¨
LC120
Press
SET
button
3x
¨
LC250
(= LC 2)
The selected oil container fl ashes in the display (here LC250).
After about 3 seconds, the display switches to the entry of the metered lubricant
delivery volume.
4.
To enter the delivery volume per pulse press the
SET
repeatedly. The delivery
volume of
0.1
...
9.5
cm³/pulse can be scrolled through in the pre-entered steps.
The delivery volume entered per pulse fl ashes in the display.
Approximately 3 seconds after the entry (inactive SET button) the setting mode
for the delivery volume is terminated.
The operating mode, the quantity of remaining pulses, the entered oil container
LC 2 (
Ö
LC250) and the metered volume to be delivered per pulse are shown on
the display.
If the number of remaining pulses is 100 or greater, the following indicator
appears in the display
>
99
.
5.
Turn on the power to the lubrication unit.
Make the electrical connection to the product see page 38.
The plug icon (cable break detection, see page 25) appears in the display and
the arrow icon
d
flashes in the display. The drive LEDs flash green at 5 s intervals.
358 814-27
358 814-28
358 814-39
358 814-40
358 814-41
358 814-42
358 814-43
358 814-44
358 814-44
EN
GLISH
358814_2017_01_EN.indd 19
16.01.2017 13:38:18
