Bosch Rexroth IndraControl VAM 11.1, Руководство по планированию проекта

Страница: 56 / 86

Reverse voltage protection Yes
Plug-in pin spacing 3.5 (Weidmüller terminal)
Fig.7-13: Characteristics of the digital inputs
7.5.4 Characteristics of the Digital Outputs
Output type Semiconductor outputs, non-saving;
protected, with automatic restart, current-carrying
Number of outputs 8
Status display by LED Green
Electrical isolation Yes (to logic supply)
Reverse voltage protection Only guaranteed without load connection.
Defect of the device caused by
●
Polarity reversal with simultaneous short-cir‐
cuit of the output lines
● polarity reversal with simultaneous connec‐
tion of externally polarized suppressor diodes
at the output lines
● Applying an external voltage > U
Q
Nominal output voltage 24 V
Rated output current
Nominal value:
UL rating: 0.2 A
0.2 A general purpose
5W Tungsten
Simultaneity factor 100 %
Plug-in pin spacing 3.5 (Weidmüller terminal)
Fig.7-14: Characteristics of the digital outputs
7.6 X81: Connection for the External Hand-Held Terminal
7.6.1 General Information
Besides the inputs for the handwheel of the hand-held terminal (A, /A, B, /B) 12
inputs (IN0 – IN11) for the keys of the hand-held terminal are available. The
keys are supplied via the "+24 V" supply via connector X81.
The "+24 V" supply is internally generated by the supply "UL" and may only be
used to connect the keys of the hand-held terminal. Connection X81 for the
hand-held terminal is located on the logic circuit board.
The states of the inputs and the counter value of the handwheel are transmitted
to the master control via PROFIBUS DP.
The module configuration and the address assignment are descri‐
bed in chapter 8 "Commissioning" on page 63 .
Bosch Rexroth AG DOK-SUPPL*-VAM*11/41**-PR03-EN-P
Rexroth IndraControl VAM 11.1/41.1 Machine Control Panels
54/83
Interfaces