46/64
HyDrotrAC GFt >130 knm
| Servicing and repair
Bosch Rexroth AG, Issue 10.2019, RE 79094
Check the oil level of the planetary gearbox
K model
.
f
Observe the information on the planetary gearbox dimensioned drawing in
appendix D “Technical data / Drawings” of the material number-specific
operating instructions!
•
Bore
10
: for filling or checking the lubricating oil
•
Bore
9
for draining the lubricating oil
1.
Allow the planetary gearbox cool down to approx. 50°C after standstill.
2.
Turn the planetary gearbox as shown in the figure on the left:
Bore
9
in 6 o'clock position.
3.
Place a catch basin with sufficient capacity under the planetary gearbox.
4.
Loosen the screw plugs of the bore
10
slowly, so that any existing pressure can
be released.
5.
Then remove the screw plug from bore
10
. The oil level is correct if some
lubricating oil escapes from the bore
10
.
6.
If the oil level is too low, fill in lubricating oil. Proceed as described in chapter
8.1.3 “Filling the planetary gearbox with lubricating oil”.
7.
Check whether the seal on the screw plug thread of the bore
10
is still in perfect
condition and can be reused. Replace a damaged seal.
8.
Seal bore
10
with the corresponding screw plug.
10.2.3 Acoustic inspections
f
Perform daily noise tests. A grinding or whistling noise that possibly occurs at
high speeds indicates a malfunction. Inform the competent superior or operator
without delay of any changes during planetary gearbox operation such as unusual
running noise.
10.2.4 Checking and tightening screw connections
f
Check, as specified in the maintenance schedule, that all screw connections
are tightly secured. Especially check:
–
the gearbox mounting screws
–
the screw plugs of bores
5
,
6
,
9
and
10
–
the motor fixing screws
f
Tighten the screws of the planetary gearbox at the torque specified for
the corresponding screws in the planetary gearbox spare parts drawing in
appendix D “Technical data / Drawings” of the material number-specific
operating instructions. Also observe the frame drawing of the machine/vehicle
manufacturer.
procedure
CorreCtion Copy 1 |17.10.2019 | onLy For internAL USe
