Bosch Radion B810, Справочное руководство

Страница: 17 / 62

Point source/RFID programming
A point’s source gives a description as to the physical location of the point for installation and
service personnel. Perform the following to program a source:
1.
Using either RPS, or a supported keypad, access the Program Menu, and select the
Points menu option.
2. Select the Source menu option
3. Select the point source of the device you are programming.
4. Change the point source to the “wireless” option.
5. Save changes.
6. Select the RFID menu option to edit the RFID of each RADION device.
7. Manually enter in the unique RFID as it appears on the RFID sticker in the illustration
below. ID’s beginning with a zero may not display in the keypad UI, or RPS
8. Save changes and exit the menu.
The control panel is now enabled to receive wireless communication information from the
RADION transmitter.
Figure 3.3: RFID sticker example (RFDW-SM-A shown)
Point indexes
Point indexes determine how points operate/respond to circumstances within a system.
Perform the following to program a point:
1.
Using either RPS, or a supported keypad, access the Program Menu, and select the
Points menu option.
2. Select the point source of the device you are programming and select the wireless device
type. Ensure that it matches that of the physical device you are enrolling.
3. Assign the desired attributes of the point index (how the device will respond to various
circumstances).
4. Save changes and exit the menu.
Signal strength test (for repeaters)
Use the following procedure to test the frequency strength and range of the RADION system.
1.
From the keypad, access the Wireless Menu, and select the Diagnostics menu option.
2. Select the RF Repeaters menu option.
RADION receiver SD RADION receiver SD | en 17
Bosch Security Systems, Inc. Reference Guide 2014.03 | 06 | F.01U.261.834