English |
17
Bosch Power Tools
1 609 929 T64 | (9.6.09)
Assembly
Delivery Scope
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before assembling the saw stand, check if all
parts listed below are provided:
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Spanner
Assembling the Saw Stand
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material.
Setting Up the Saw Stand (see figures A1 – A2)
– Lay the saw stand upside down on the floor
(legs facing upward).
– Push the locking pin
3
in and tilt the leg out-
ward until the locking pin can be heard to en-
gage.
– Repeat this workstep with the other three
legs.
– Turn around the saw stand to the working
position.
The manufacturer logo must face toward the
front so that it can be read.
– Ensure that the saw stand is stable and that
all locking pins have engaged.
The saw stand is easily aligned with the height-
adjustable leg
4
.
– Loosen lock nut
14
and screw the leg in or
out until the saw stand is aligned level and all
four legs face against the floor.
Mounting the Length Stop and Workpiece
Support (see figures B1–B2)
– Screw the length stop
6
to the workpiece
support
8
with carriage bolt
M6 x 46
and
locking knob
7
.
– Insert the workpiece support into the table
extension
10
.
– Tighten the locking knob
9
to lock the work-
piece support.
– Repeat the worksteps with the second work-
piece support.
No.
Designation
Quan-
tity
Saw stand PTA 2400
1
1
5
Attachment set
Locking knob of the attach-
ment set
2
2
2
Retaining adapter
2
12
Retaining adapter fastening kit
consisting of:
– Assembly-sliding plate
– Hexagon bolt (M8 x 15)
– Washer
4
4
4
8
Workpiece support
2
6
7
Length stop
Locking knob of the length
stop
Carriage bolt (M6 x 46)
2
2
2
13
Power tool fastening kit
consisting of:
– Hexagon bolt (M8 x 50)
– Washer
– Wing nut
4
8
4
OBJ_BUCH-940-002.book Page 17 Tuesday, June 9, 2009 1:44 PM
