8
| English
1 609 92A 0HH | (18.11.13)
Bosch Power Tools
Operation
Working Advice
Do not overload the saw stand. Always observe the maximum
carrying capacity of the saw stand and the two table exten-
sions.
Always hold the workpiece firmly, especially the longer and
more heavy section. After cutting through the workpiece, the
centre of gravity may become dislocated in such an unfavour-
able manner that the saw stand tips over.
If possible, always place the workpiece on one or both work-
piece supports.
Extending the Saw Stand (see figures E – F)
Long workpieces must be underlaid or supported at their free
end.
– Place your long workpiece onto the saw table of the power
tool.
– Loosen locking knob
4
and pull the table extension
2
out to
the desired clearance.
– Retighten the locking knobs again.
– Loosen locking knob
1
and adjust the height of the work-
piece support
3
so that the workpiece rests level.
– Retighten the locking knobs again.
– Repeat the worksteps with the second workpiece support.
Maintenance and Service
After-sales Service and Application Service
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the saw stand.
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch’s application service team will gladly answer questions
concerning our products and their accessories.
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: (01300) 307044
Fax: (01300) 307045
Inside New Zealand:
Phone: (0800) 543353
Fax: (0800) 428570
Outside AU and NZ:
Phone: +61 3 95415555
www.bosch.com.au
Disposal
The saw stand, accessories and packaging should be sorted
for environmental-friendly recycling.
Subject to change without notice.
OBJ_BUCH-2132-001.book Page 8 Monday, November 18, 2013 2:34 PM
