Bosch Professional Heavy Duty GAS 35 H AFC, Оригинальное руководство пользователя

Страница: 25 / 313

English | 25
– Insert the accessories into the holders provided for them:
Suction tubes (33) into the holders (20) , crevice
nozzle (29) into the holder (21) , floor nozzle (32) into
the holder (22) .
– Open the elastic bands of the vacuum hose holder (4)
and wrap the vacuum hose (25) around the top part of
the dust extractor in the holder (4) .
Hook the elastic bands back in.
– Only ever carry the dust extractor by the carrying
handle (10) .
– Store the dust extractor in a dry room and secure it so
that it cannot be used by unauthorised persons.
– Put the castor brake (15) down to hold the castors (16)
in place.
Rectifying faults
u
If a fault (e.g. a filter damage) occurs, the vacuum
cleaner must be switched off immediately. The fault
must be repaired before resuming operation.
Warning! The dust extractor contains dust particles that pose a risk to health. Observe all the safety warnings in these in-
structions.
Problem Corrective measures
Suction turbine will not switch on. – Check the mains cable, mains plug, fuse, socket and fill level sensors (40) .
The mode selector switch (7) is set to "automatic start/stop".
– Set the mode selector switch (7) to the "vacuuming" symbol or switch on the
power tool plugged into the plug socket (5) .
The suction turbine switches off. – Empty the container (1) .
The suction turbine will not switch on
again after the container has been
emptied. – Switch the dust extractor off and wait five seconds before switching it back on.
– Clean the fill level sensors (40) and the space between the fill level sensors (40)
using a brush.
The suction power is decreasing. – Remove any blockages from the vacuum nozzle, suction tube (33) , vacuum hose
(25) or flat-pleated filter (28) .
– Change the disposal bag (27) or safety filter bag (26) .
– Make sure the filter cover (39) is engaged correctly.
– Place the top part of the dust extractor (12) on correctly and close the catches
(13) .
– Change the flat-pleated filter (28) .
Dust is escaping during extraction – Check that the flat-pleated filter (28) has been fitted correctly.
– Change the flat-pleated filter (28) .
Automatic switch-off (wet extraction)
is not working. – Clean the fill level sensors (40) and the space between the fill level sensors (40)
using a brush.
Automatic switch-off will not work in the presence of non-conductive liquids or foam-
ing.
– Check the fill level regularly.
Acoustic warning signal sounds. Suction power setting too low.
– Set the suction power regulator (8) to a higher setting.
Hose diameter setting is wrong.
– Set the volume flow controller (6) to the correct vacuum hose diameter.
Vacuum hose (25) is blocked or twisted.
– Remove blockage or untwist hose.
Disposal bag/safety filter bag full.
– Change the disposal bag (27) or safety filter bag (26) .
Flat-pleated filter (28) is dirty.
– Clean or change the flat-pleated filter if required.
The airflow supplied by the connected power tool is insufficient.
Bosch Power Tools 1 609 92A 71M | (01.12.2021)