Bosch PIN6 N1, Инструкция по эксплуатации

Страница: 11 / 16

11
Once the time has elapsed
Once the time has elapsed, a beep will sound.
‹‹
and
U
are
displayed in the time program function display. After pressing
the 0 symbol, the indications turn off.
Changing or cancelling the time
Press the
0
symbol, the
U
indicator lights up.
Change the time using the
1
to
9
symbols or press
0
to cancel.
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
>D
symbol. A signal sounds. The control panel is
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note:
The lock does not affect the main switch. The hob may
be switched off when desired.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
”‰
symbol and the residual
heat indicator
œ
/
•
flash alternatively in the display.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Basic settings
The device has several basic settings. These settings may be
adapted to the user's individual needs.
Indicator Function
™‚ Childproof lock
‹
Deactivated.*
‚
Activated.
™ƒ
Sound signals
‹
Confirmation beep and error signal deactivated.
‚
Only confirmation beep deactivated.
ƒ
All signals activated.*
™†
Automatic timer
‹
Switched off.*
‚
-
ŠŠ
Automatic shut-off time.
™‡
Duration of the time program function warning signal
‚ 10 seconds*.
ƒ
30 seconds.
„
1 minute.
™ˆ
Power-Management function
‹ = Deactivated.*
‚
= 1,000 W. minimum power.
‚
= 1,500 W.
ƒ
= 2,000 W.
etc.
Š
or
Š
. = maximum power of the hob.
™Š
Hotplate time selection
‹
Unlimited: the last hotplate programmed remains selected.*
‚ Limited: The hotplate will only remain selected for 10 seconds.
*Factory settings