English - 3
External Dust Extraction
The chip ejector 3 fits on both sides for direct
connection of the Bosch vacuum hose
Ø – 35 mm 19 (accessory). When using other
vacuum hose systems a suitable extraction
adapter may be required.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Integrated Dust Extraction
A chip/dust bag 20 (accessory) can be used for
smaller jobs.
Empty the chip/dust bag regularly. Remove the
chip/dust bag, open the zipper and empty the
chip/dust bag.
Choice of Chip Ejector Side
(Right/Left)
The chip ejector 3 can be switched to the right or
left with the selector lever 6.
Always press the change lever until it engages in
the end position.
The selected ejector direction is marked with an
arrow.
Blade Protector (see figure
)
The blade protector 21 allows the machine to be
set down directly after operation, without danger
of damaging the working surface or the planer
blade.
When planing, the blade protector 21 is tilted up-
wards thus enabling full contact of the rear part of
the planer base plate 11.
For stationary use (e. g. with base unit UG 37),
the blade protector must be removed. Press the
blade protector together from the sides and pull it
off.
For non-stationary use, the blade protector
must always be assembled.
Planing
Set the required planing depth and place the front
part of the planer base plate 11 against the work-
piece.
Caution! Danger of kickback!
Apply the machine to the workpiece
only when switched on.
Switch the machine on and guide the machine
with an even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer base plate.
When machining hard materials (e. g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required. Repeat the planing sev-
eral times.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
Beveling Edges (see figure
)
The V-grooves 12 in the front planer base
plate 11 allow quick and easy beveling of work-
piece edges. Depending on required bevel width,
use the corresponding V-groove.
For this, place the planer with the V-groove 12
onto the edge of the workpiece and guide along
the edge.
Using the Parallel/Beveling Guide
(Accessory – see figure
)
Mount parallel guide 13 or beveling guide 17 to
the machine using fastening bolt 14 and rebating
depth stop 2 using fastening bolt 1.
Loosen locking nut 15 and adjust the required re-
bating width with the scale 16. Retighten locking
nut 15 again.
Adjust the required rebating depth accordingly
with the rebating depth stop 2.
Carry out the planing procedure several times,
until the required rebating depth is reached. Pay
attention that the planer is guided with sideward
supporting pressure.
Beveling (only beveling guide 17)
When beveling rebates and surfaces, adjust the
required slope angle with the angle adjust-
ment 18.
Operating Instructions
B
C
D
11 • 2 609 932 291 • TMS • 30.01.03
mikosoft praha s.r.o. mikosoft praha s.r.o.
mikosoft praha s.r.o.
mikosoft praha s.r.o.
