English–
3
0 275 U07 PDS | (21.4.16)
Bosch eBike Systems
Operating your Bosch Drive Unit
Safety Rules
Read and understand all safety warnings and
instructions.
Failure to follow the warnings be-
low could result in death or serious injury.
Save all safety warnings and instructions for future
reference.
The term “battery pack” used in these operating instruc-
tions refers both to standard battery packs (battery packs
with holder on the bike frame) and to rack-type battery
packs (battery packs with holder in the rear rack/carrier).
Do not open the drive unit yourself. The drive unit
must be repaired only by qualified experts and only
with original spare parts.
This will ensure that the safe-
ty of the drive unit is maintained. Unauthorized opening
of the drive unit will void warranty claims.
All components attached to the drive unit and all oth-
er components of the eBike drive (e.g., the chain-
wheel, chainwheel seat, pedals) may be replaced on-
ly with identical components or components
specifically approved for your eBike by the bicycle
manufacturer.
This protects the drive unit against over-
load and damage.
Remove the battery pack from the eBike before begin-
ning work (e.g. inspection, repair, assembly, mainte-
nance, work on the chain, etc.) on the eBike, trans-
porting it by car or plane, or storing it.
Unintentional
activation of the eBike system poses a risk of injury.
The eBike system can switch itself on when the eBike
is pushed backwards.
Using the walk assistance function is only recom-
mended when pushing the eBike.
There is risk of injury
if the wheels of the eBike are not in contact with the
ground while using the walk assistance.
Use only original Bosch battery packs approved for
your eBike by the manufacturer.
Using other battery
packs can lead to injuries and pose a fire hazard. When
using other battery packs, the warranty is void and
Bosch shall not assume any liability.
Do not make any modifications to your eBike system
or attach any other products which would be suitable
for increasing the performance of your eBike sys-
tem.
Unauthorized modification of the system could re-
sult in death or serious injury.
Please follow all local, state and federal regulations
when registering and using eBikes.
Read and observe the safety warnings and instruc-
tions in all operating instructions of the eBike sys-
tem and your eBike.
Product Description and
Specifications
Intended Use
The drive unit is intended only for driving your eBike and
must not be used for other purposes.
Technical Data
Drive unit
Drive Unit Speed
Article number
0 275 007 041
Rated continuous power
W
250
Torque at drive, max.
Nm
63
Rated voltage
V
36
Operating temperature
°F
+23...+104
Storage temperature
°F
+14...+122
Degree of protection
IP 54 (dust and splash
water protected)
Weight, approx.
lb
8.8
Bike lights
1)
Voltage, approx.
2)3)
V
6/12
Maximum output
– Front light
– Rear light
W
W
8.4/17.4
0.6/0.6
1) Not possible via the eBike battery pack in all country-specific
versions, depending on the statutory regulations
2) The voltage level is preset and can be changed only by the eBike
dealer.
3) When changing the bulbs, ensure that the bulbs are also compatible
with the Bosch eBike system (ask your eBike dealer) and that the spec-
ified voltage matches. Bulbs must be replaced only with bulbs of the
same voltage.
Incorrectly installed bulbs can be destroyed or cause damage
to the system.
OBJ_BUCH-2867-001.book Page 3 Thursday, April 21, 2016 4:36 PM
