Bosch NKN 710 Series, Руководство по установке

Страница: 15 / 30

Feed cables through the housing rear
The rear holes allow cable to be fed through the supplied glands or the direct connection of
conduit fittings.
1.
Remove the dome plugs located at the rear of the housing.
2. Screw the cable glands into the holes at the rear of the housing. The holes accept either
3/8‑in NPT or 1/2‑in NPT cable glands or conduit fittings. (The M20 x 1.5 cable gland can
also be used.)
3. Feed the power cable through one of the glands.
4. Feed the video/ethernet cable through a separate cable gland.
To fit the cables through the NPT fitting in the housing:
Ethernet cable: remove the RJ-45 connector and then crimp the connector back on the
cable once it is pulled through the gland. Crimp in accordance with the connector
manufacturer’s recommendations (the camera connector is Auto MDIX compliant).
Video cable: remove the BNC connector and then crimp the connector back on the cable
once it is pulled through the gland.
5. Feed any audio and alarm cables through a separate gland as required.
6. Apply a seal around the cables in their glands. Use RTV or an equivalent seal (a split
rubber sleeve may also be used).
7. Tighten the cable glands. The tightening force required is approximately 1 to 1.5 turns
past the point where the gland starts to grip the wire. Failure to correctly tighten the
glands could result in water ingress.
8. Ensure that all open holes are covered with the rubber plugs provided.
6.3
DINION Housing Kit Connecting cables in housing | en 15
Bosch Security Systems Installation Manual 2014.11 | 1.0 | F.01U.309.609