Bosch NGM5458UC, Руководство по установке

Страница: 13 / 52

Conversion to LP gas
en-us
13
4.9 Checking the installation
Check if your unit is working properly after you have com-
pleted the installation steps.
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
1.
Ensure that the burner caps are properly positioned.
2.
Turn each burner on in turn and verify that the electric
igniters are working.
3.
Turn the control knob between the highest and lowest
setting. Make sure the flame does not go out and there
are no flashbacks.
4.
If you have carried out an LP gas conversion, check the
lowest setting to confirm the flames are stable on the
ports and the set screws do not need to be readjusted.
5.
Check the flame characteristics.
The flame should be blue with a minimal yellow tip on
the outer cone.
6.
After completing all checks, complete the installation of
the horizontal panel or oven. →
Page 9
Note: The appliance is shipped from the factory for use
with natural gas. If you want to use propane gas, it must
be converted. A qualified technician or installer must do
the conversion. Refer to Conversion to LP gas.
→
Page 13
Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note: Allow the appliance to operate for 4 to 5 minutes before evaluating the flame. Some yellow streaking is normal dur-
ing the initial startup.
Flame Image Measure
Completely or mostly
yellow
Verify that the regulator is set for the correct fuel. Retest af-
ter adjustment.
Yellow tips on outer
cone
Normal for LP gas
Soft blue Normal for natural gas
Conversion to LP gas 5 Conversion to LP gas
Conversion to LP gas
Your appliance is equipped for use with natural gas on de-
livery. It can be converted to LP gas supply.
The components required for conversion to LP gas are
contained in the LP conversion kit included with this appli-
ance, or are available from Customer Service.
→
"Customer Service", Page 16
Only a qualified technician or installer is authorized to con-
vert the appliance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
5.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Requirement: Complete the installation instructions in this
manual up to and including section
→
"Securing the cooktop in the countertop", Page 10 be-
fore starting the LP conversion.