Bosch MUM58M59, Инструкция по эксплуатации

Страница: 8 / 174

8
en Operation
Important information
concerning the use of the whisk
Figure
E
:
The whisk should almost touch the bottom
of the bowl to ensure that the ingredients
are optimally mixed. If not, adjust the height
of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move the swivel arm to
position 2 .
■ Insert the whisk into the drive
until the whisk locks into position.
■ Hold whisk in place and loosen nut
clockwise using open-ended wrench
(size 8).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti-clockwise: Lower
■ Press the Release button and
move the swivel arm to
position
1
.
■ Check the height of the whisk and,
if required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2 .
■ Hold whisk in place and tighten nut
anticlockwise using open-ended wrench
(size 8).
Working with the bowl and the tools
Fig.
F
:
■ Press the Release button and
move the swivel arm to
position 2 .
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig.
E
-4b) .
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1 .
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Our recommendation:
–
Professional flexi stirring whisk:
first stir in at setting 1-2,then setting 3-5
as required
– Professional beating whisk:
setting 7, mix in at setting 1
–
Kneading hook:
first stir in at setting 1, knead at setting 3
Adding more ingredients
■ Switch off the appliance with the rotary
switch.
■ Add more ingredients through the feed
tube in the cover.
or
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2 .
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2 .
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see “Cleaning and
servicing”.
Continuous-feed shredder
W Risk of injury
Do not grip the sharp blades or edges
of the cutting discs. Take hold of cutting
discs by the edge only. Before attaching /
removing the continuousfeed shredder,
wait until the drive has come to a standstill
and pull out the mains plug. Do not reach
into the feed tube.