LTC9349MK |
Instruction Manual
|
Installation
Bosch Security Systems | 21 July 2003
EN
| 3
3
INSTALLATION
Backbox Module Mounting in Suspended Ceiling
Mount the backbox in a suspended ceiling grid using
the existing ceiling tile, as follows.
1. Locate the bracket assembly at the desired location
(PHOTO 2). Loosen the securing screws on the
base bracket assembly (PHOTO 4) enough to retain
the suspension bars during handling, but allowing
adjustment during installation.
Photo 2: Ceiling Mounting (Top View)
2. Snap the bar clips over the ceiling rails (PHOTO 3).
Slide the base plate to the desired position on top
of the tile.
Photo 3: Bracket Clip Fitting
3. Tighten the 4 bracket screws located in each corner
(PHOTO 4).
Photo 4: Bracket Securing Screws
4. Secure the bracket assembly to an overhead
securing point using a safety cable (PHOTO 5).
Photo 5: Safety Cable Fitment
5. Cut a 172 mm (6.75-inch) diameter hole in the
center of the mounting plate using two (2) pencils
(or a pencil and nail) and the template tool
(provided with the LTC 9349 Unity Dome Series).
6. Install the unit as instructed in the
LTC 9349 Unity Dome Series manual.
Ceiling Tile
Suspension
Bars
Ceiling Base
Bracket
x 4
x 4
