Bosch Lambdatronic LT4 ADV, Быстрый старт

Страница: 8 / 12

To change a value, double‐click the value, type in the desired new value, and
then hit the Enter or Return key. Some variables can be changed through drop‐
down boxes as well.
Once a variable is changed, an arrow will appear next to the value to indicate the
direction in which the variable was changed.
To write new values to the ECU, select the button “Write data to ECU” from the
ribbon under the “Start” tab:
Live Viewing of Measurements
To start live viewing, select the button “Start” in the “Measurement” section of
the ribbon under the “Start” tab (red box in the figure below):
If you are using the pre‐made workfolder and worksheets, measurements are
shown in the “Monitor” worksheet.
To record data, select the “Start” button in the “Recording” section of the ribbon
under the “Start” tab (green box in the figure above). Selecting this brings up a
prompt where a save location can be specified. To stop the recording, click the
“Start” button in the “Recording” section again. Recordings can be opened in
Bosch Motorsport’s WinDarab analysis software.
3.4
3 | Calibration and Live Data Viewing/Recording
8 / 12 Lambdatronic LT4 ADV Bosch Motorsport