Bosch KN6 DV1 Series, Руководство пользователя

Страница: 13 / 24

Wipe protection
en
13
2.
Touch ⁠.
a
lights up on the heat setting display.
12 Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
12.1 Activating wipe protection
▶
Touch .
a
A signal sounds.
a
The display above lights up.
a
The control panel is locked for 30 seconds.
13 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→
Page 13
14 Basic settings
You can configure the appliance to meet your needs.
14.1 Overview of the basic settings
You can find an overview of the basic settings and the
default factory settings here.
Dis-
play Selection
Automatic childproof lock
– Switched off
1
– Switched on
– Manual and automatic childproof lock are
switched off.
Signal tone
– Confirmation signal and operating error
signal are switched off. The main switch sig-
nal remains switched on.
– Only the operating error signal is
switched on.
– Only the confirmation signal is switched
on.
– Confirmation signal and operating error
signal are switched on.
1
1 Factory setting
Dis-
play Selection
⁠ ⁠ Energy consumption display
Ask your electricity supplier what the mains
voltage is.
– Consumption display is switched off.
1
– Consumption display at mains voltage of
230 V.
– Consumption display at mains voltage of
400 V.
– Consumption display at mains voltage of
220 V.
– Consumption display at mains voltage of
240 V.
Automatic timer
- Switched off.
1
⁠- - Cooking time after which the hotplates
switch off.
Duration of the timer end signal
– 10 seconds.
1
– 30 seconds.
– 1 minute.
⁠ ⁠ Activation of the heating elements
– Switched off
– Switched on
– The last setting before switching off the
hotplate.
1
Resetting to the factory settings
– Switched off.
1
– Switched on.
1
Factory setting
→
"Overview of the Home Connect settings", Page 15
→
"Overview of the hood control settings", Page 18