67
• Applicable Model
Remote Controller
Remote controller
RCM3211
KM3211WH
Main
Can be used without the remote controller (main appliance only). The hot water temperature on
the RCM3211 can be switched between four settings (75, 60, 50, & 40°C).
Refer to the following for the setup method. When 75 or 60°C is set, the water is very hot, so
make sure that a mixing valve is installed.
* Up to three remote controllers can be connected. Additional remote controllers cannot be con-
nected by themselves.
Changing the temperature for operation of the main body
•
The remote controller must be installed in accordance with the installation manual enclosed in the
package.
•
KM3211WHQ cannot be used without a remote controller (main appliance body only).
•
Press the [
] or [
] button on the remote controller prior to switching on the controller. Changes
must be made within 10 minutes of the power being supplied to the unit. If the display does not
switch to maintenance mode despite pressing the [
] or [
] buttons, unplug the power and
repeat the above procedure.
•
The item number and data are shown as well as "Maintenance". (Initial setting for the item number
is "99".)
•
When the [
] button is pressed, the "99" displayed will change to 10, 11, ....,1F, 20, 21, etc..., and
conversely when the [
] button is pressed, the "99" displayed will change to 10, FF, FE, FD, FC,
27, etc...
Item No.
Temp.
* Factory Default Setting
14
ON
40
°
C
15
ON
• Press [
] button to switch between ON and OFF.
Note: The setting changes can be cancelled by pressing the Power On/Off button before confirming
the settings, or if the unit is left alone for ten minutes without confirming the settings. If the
default setting needs to be changed again, disconnect the electrical power to the unit, recon-
nect it and follow this procedure again.
• Once setup is complete, press the [
] and [
] buttons simultaneously for at least five seconds
while the item number is blinking. Once completed, a buzzer sounds. (The modified setup will not be
recorded unless this step is performed.)
50
°
C
ON
OFF
75
°
C
OFF
ON
OFF
60
°
C
OFF
• 14 and 15 are set as per procedure 3. When the setup switch is pressed, "ON" or "OFF" blink.
RCM3211 (included)
KM3211WHQ
