Home Connect
en
25
10.4 Checking the signal
strength
You should check the signal strength
if no connection could be estab-
lished.
1.
Press
.
a
lights up and the sub-
menu display shows
.
2.
Press
/
(Submenu) re-
peatedly until the submenu display
shows .
a
The submenu display shows a
value between setting (no recep-
tion) and (full reception).
3.
Press
.
Note:
The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
▶
Carry out one of the solution op-
tions:
‒
Place the router and refrigerator
closer together.
‒
Ensure that the connection is
not interfered with by screening
walls.
‒
Install a repeater to strengthen
the signal.
10.5 Installing updates for the
Home Connect software
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note:
If updates are available, the
submenu display shows
.
To cancel the update and reset the
submenu display to the set temperat-
ure, press any touch field.
1.
Press
.
a
lights up and the sub-
menu display shows
.
2.
Press
/
(Submenu) re-
peatedly until the submenu display
shows
and the submenu setting
display shows .
3.
Press
(Submenu setting).
a
The submenu setting display
shows an animation.
a
The update is installed.
a
The control panel is locked during
the installation.
a
If the installation is successful, the
submenu setting display shows
.
4.
If the submenu setting display
shows , the appliance was un-
able to install the update.
‒
Repeat the process at a later
point.
5.
If the update cannot be completed
after several attempts, contact cus-
tomer service →
10.6 Resetting Home Connect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the Home Connect settings.
1.
Press
.
a
lights up and the sub-
menu display shows
.
2.
Press
/
(Submenu) re-
peatedly until the submenu display
shows and the submenu setting
display shows .
3.
Press
(Submenu setting).
a
The submenu setting display
shows an animation for approx.
15 seconds.
a
The submenu setting display then
shows
.