Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, NY 14450
USA
www.boschsecurity.com
© Bosch Security Systems, Inc., 2010
F01U167054-01
Installation Guide
8/10
ISW-EN4200 Serial Receiver
Page 4 of 4
4.0
Register the RF Transmitters
You must register all transmitters and repeaters with the
ISW-D8125CW-V2. Bosch Commercial Wireless devices employ
wireless registration, so there is no need to connect the transmitter
to the ISW-D8125CW-V2. No data is written to the transmitter
during registration.
To register transmitters and repeaters (end devices):
1.
Program the transmitter as described in the ISW-D8125CW-V2
Installation and Operation Guide (P/N: F01U161691).
2.
When prompted by the ISW-D8125CW-V2, press the RESET
button on the end device.
-
Press the end device
’
s RESET button once if the
ISW-D8125CW-V2 is set to accept registration after a
single reset message
-
Press the end device
’
s RESET button twice if the
ISW-D8125CW-V2 is set for a double button push.
-
Depending on which ISW-EN4200 Serial Receiver received
the reset message, either the RX1 LED or the RX2 LED on
the ISW-D8125CW-V2 lights when the first reset message
is received.
-
Depending on which ISW-EN4200 Serial Receiver received
the reset message, either the RX1 LED or the RX2 LED on
the ISW-D8125CW-V2 lights when the last reset message is
received.
3.
When the end device is successfully registered, the
ISW-D8125CW-V2 shows
“
Programmed
”
on its keypad display.
4.
From the control panel, perform a walk test to ensure all
registered devices work as expected. To perform a walk test,
refer to your control panel documentation.
5.0
ISW-EN4200 LEDs
Use the following LEDs to monitor serial receiver operation.
Refer to Table 1 below and Figure 1 on page 1.
Table 1:
ISW-EN4200 LEDs
LED
Description
TX Transmit
LED
Lights when the serial receiver is transmitting
data to the ISW-D8125CW-V2.
RX
Receive LED
Lights when the serial receiver is receiving data
from the ISW-D8125CW-V2.
DEC Decode
LED
Lights when the serial receiver is decoding an RF
transmission from a Commercial Wireless device.
6.0
Specifications
Housing Dimensions
(H x W x D)
162 x 91.4 x 27.9 mm
(6.4 x 3.6 x 1.1 in.)
Weight
14.2 g (0.5 oz)
Power Requirements
12 VDC at 1 W
Maximum Current Draw
100 mA
Operating Environment
0
°
to 60
°
C (32
°
to 140
°
F), 90%
relative humidity, non-condensing
Compatible Control
Panels
GV3 Series: D9412GV3,
D7412GV3, D7212GV3
GV2 Series: D9412GV2,
D7412GV2, D7212GV2
G Series: D9412G, D7412G,
D7212G
9000 Series: D9412, D9112,
D7412, D7212
(Firmware 6.3 or later)
