Bosch HMV3052C, Руководство по установке

Страница: 12 / 36

12
Adapting microwave blower for wall venting
1.
Remove and save the screws holding the blower
motor and the blower plate. Lift up the blower plate
and put it aside.
2.
Carefully pull out the blower unit and rotate 90º so that
fan blade openings are facing out the top of the
microwave.
3.
Rotate the blower unit counterclockwise 180º.
4.
Gently remove the wires from the grooves. Reroute the
wires through the grooves on other side of the blower
unit. Rotate blower unit 90º so that fan blade openings
are facing out the back of the microwave.
9
CAUTION
Do not pull or stretch the blower unit wiring. Make
sure the wires are not pinched, and that they are
properly secured.
5.
Place the blower unit back into the opening.
6.
Replace the blower plate and secure with the screws
removed in Step 1.
7.
Use tin snips to cut and remove knockouts from the
rear plate of the microwave oven. Discard knockouts.
Be careful not to distort the plate.
8.
Attach the exhaust adapter to the rear of the oven by
sliding it into the guides. Push in securely until it is in
the lower locking tabs. Make sure the damper hinge
swings freely.
Preparing cabinet
1.
Remove power to outlet.
2.
Remove all contents from upper cabinet.
3.
Tape the TOP CABINET TEMPLATE onto the bottom
surface. Make sure the template centerline aligns with
the vertical line on the wall. Rear wall arrows must be
against rear wall.
Note:
For recessed cabinet bottom, trim the template
edges so that it fits inside the recessed area. The
template has trim lines to use as guides.
4.
Drill 3\8" (9,5 mm) holes at "A", "B" and "C".
Note:
Wear safety goggles when drilling holes in the
cabinet bottom.
5.
Cut out the 2" (50,8 mm) hole at "D". This hole is for
the power supply cord.
Note:
If the cabinet is metal, use the nylon grommet
around the opening to protect the cord.
'
(