Bosch HEZBS301, Руководство по установке

Страница: 5 / 24

9001050650 Rev A English 3
Low Backguard Installation
Procedure for a Gas Slide-In-
Range (Low Backguard, Gas
HGZBS301)
Tools Needed
• Torx T20 screwdriver
• gloves
Preparation
9
IMPORTANT!
Can you slide the range out enough to have access to the
rear and side screws of the rear louver cover and trim?
• If you can slide the range out, continue with the
procedure,
• If you cannot slide the range out, contact a qualified
service person to disconnect the gas or electrical
connections that prevent the range from being pulled
out before proceeding.
• Read the Tip Over Warning in the Safety section of this
manual. Be aware of this when the range has been
pulled out of the anti-tip bracket for this installation.
Procedure
1. Confirm that the range and cooktop grates are cool
enough to be comfortably touched at the rear.
2. Slide the range out enough to access the rear louver
cover mounting screws.
3. Remove the four screws holding the rear louver cover.
Save these screws to reattach the louver cover.
Figure 1: Rear louver cover screw locations
4. Lift the louver cover out of the slots holding it in place.
Note the slot locations for later.
5. Remove the cooktop grates.
6. Remove the screws holding the trim (five screws on the
back and one screw on each end). Save these screws
for installation of the Low Backguard.
Figure 2: Trim screw locations (louver cover removed)
7. Rotate the trim forward, slide slightly to the front, and
lift it off.
8. Place the Low Backguard in position A (See Figure 3:
Low Backguard placement) and then move it to
position B (engaging the alignment device 1) (the
appearance of the devices may not be exactly as
shown). Rotate the Low Backguard to a vertical
position, aligning hole 2 with the holes at 3 on both
sides of the range.