Bosch HB.13B Series, Инструкция по эксплуатации

Страница: 9 / 24

9
Changing the basic settings
This oven has different basic settings. The settings can be
adapted to the user's own needs.
No other time function can be programmed.
1.
Press the
0
button for approximately 4 seconds.
The display panel will show the current basic setting for the
time, e.g.
™‚ for the Selection ‚ .
2.
Set the basic setting using the buttons @ or A .
3.
Confirm with the 0 button.
The display panel shows the following basic setting. Using
the button
0
select the levels and using the buttons
@
or
A
make the setting.
4.
Press the 0 button for approximately 4 seconds.
All basic settings have been applied.
The basic settings can be changed again at any time.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
■
Different colours may be seen in your front panel due to the
various materials used in its manufacture, such as glass,
plastic and metal.
■
Dark patches in the door's glass panel may seem to be dirt
but they are in fact reflections from the oven light.
■
Enamel burns at very high temperatures. This may cause
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
■
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners
Wash new dishcloths thoroughly before use.
Basic settings
Selection ‚ Selection ƒ
Selection
„
™‚
Time indicator always* only with
the
button
0
-
™ƒ
Duration of signal
after the cooking
time or the time set
on the timer has
elapsed
approx.
10 sec
approx.
2 min.*
approx.
5 min
™„
Time until a setting is
applied
approx.
2 sec
approx.
5 sec.*
approx.
10 sec.
* Default setting
Zone Cleaning products
Front panel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass cleaning
product or a glass scraper.
Stainless steel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or egg
white stains since corrosion could
occur underneath these marks or
stains.
Special products for the care of stain-
less steel and which are suitable for hot
surfaces may be obtained from Techni-
cal Assistance Service centres and
specialist retail outlets. Use a very fine
soft cloth to apply the cleaning product.
Glass panel Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Display Glass cleaning products:
Clean using a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass panels on oven
door
Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Glass cover for the
oven light
Hot water and a little soap:
Clean with a dishcloth.
The seal
Do not remove!
Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Wire shelves or rails Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do
not leave this to soak or wash in a dish-
washer.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or
brush.