Bosch GWS 1000 PROFESSIONAL, Оригинальное руководство пользователя

Страница: 27 / 368

28 | English
1 609 929 K94 | (27.10.08) Bosch Power Tools
Flap Disc
f
For operations with the flap disc, always
mount the hand guard 14.
Rubber Sanding Plate
f For operations with the rubber sanding
plate 15, always mount the hand guard 14.
See graphics page for the mounting sequence.
Screw on the round nut
17 and tighten with the
two-pin spanner.
Cup Brush/Disc Brush
f
For operations with the cup brush/wheel
brush, always mount the hand guard 14.
See graphics page for the mounting sequence.
The cup brush/disc brush must be able to be
screwed onto the grinder spindle until it rests
firmly against the grinder spindle flange at the
end of the grinder spindle threads. Tighten the
cup brush/disc brush with an open-end span-
ner.
Quick-clamping Nut
For convenient changing of grinding tools with-
out the use of additional tools, you can use the
quick-clamping nut
10 instead of the clamping
nut 9 .
f
The quick-clamping nut 10 may be used only
for grinding or cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 10.
When screwing on, pay attention that the side
of the quick-clamping nut 10 with printing
does not face the grinding disc; the arrow must
point to the index mark 21.
Lock the grinder spin-
dle with the spindle
lock button
2 . To tight-
en the quick-clamping
nut, firmly turn the
grinding disc in clock-
wise direction.
A properly attached,
undamaged quick-
clamping nut can be
loosened by hand
when turning the
knurled ring in anti-
clockwise direction.
Never loosen a tight
quick-clamping nut
with pliers. Always
use the two-pin span-
ner.
Insert the two-pin
spanner as shown in
the illustration.
Approved Grinding Tools
All grinding tools mentioned in these operating
instructions can be used.
The permissible speed [min
-1
] or the circumfer-
ential speed [m/s] of the grinding tools used
must at least match the values given in the table.
Therefore, observe the permissible
rotation-
al/circumferential speed on the label of the
grinding tool.
21
max.
[mm] [mm]
D b d [min
-1
] [m/s]
115
125 6
6 22.2
22.2 11000
11000 80
80
115
125 –
– –
– 11000
11000 80
80
75 30 M 14 11000 45
b
d
D
D
D
b
d
OBJ_BUCH-310-002.book Page 28 Monday, October 27, 2008 2:16 PM