Bosch GTM 12 Professional, Оригинальное руководство пользователя

Страница: 40 / 45

66 | English
1 609 929 U05 | (9.6.09) Bosch Power Tools
Aligning the Angle Indicator (Vertically)
(see figure R)
– Bring the power tool into the chop and mitre
saw working position. (see “Working Posi-
tion”, page 59)
– Turn the saw table 24 to the 0° detent 29 .
The lever 28 must be felt to engage in the de-
tent.
Checking:
The angle indicator 49 must be in alignment
with the 0° mark of the scale 50 .
Adjusting:
– Loosen the screw 58 with the slotted screw-
driver provided and align the angle indicator
alongside the 0° mark.
– Afterwards, check to ensure that the adjust-
ment made is correct for the 45° mark.
– Retighten the screw again.
Aligning the Fence
– Bring the power tool into the table saw work-
ing position. (see “Working Position”,
page 67)
– Turn the saw table 24 to the 0° detent 29 .
The lever 28 must be felt to engage in the de-
tent.
Checking: (see figure S1)
– Adjust an angle gauge to 90° and position it
between the fence 32 and the saw blade 7 on
the saw table 24 .
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure S2)
– Loosen all Allen screws 39 with the Allen key
provided.
– Turn the fence 32 until the angle gauge is
flush over the complete length.
– Retighten the screws again.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the power tool into the table saw work-
ing position. (see “Working Position”,
page 67)
– Turn the saw table 24 to the 0° detent 29 .
The lever 28 must be felt to engage in the de-
tent.
Checking: (see figure T1)
– Adjust an angle gauge to 90° and position it
on the saw table 24 .
The leg of the angle gauge must be flush with
the saw blade
7 over the complete length.
Adjusting: (see figure T2)
– Loosen the nut (size 10 mm) of the Allen
screw 59 .
– Screw the Allen screw 59 with a suitable Al-
len wrench (size 3 mm) in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the nut again.
In case the angle indicator 49 is not in a line with
the 0° mark of the scale 50 after the adjust-
ment, the angle indicator must be aligned ac-
cordingly (see “Aligning the Angle Indicator
(Vertically)”, page 66).
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the table saw work-
ing position. (see “Working Position”,
page 67)
– Turn the saw table 24 to the 0° detent 29 .
The lever 28 must be felt to engage in the de-
tent.
– Release the clamping lever 38 and tilt the
tool arm leftward to the stop (45°) by the
handle
20 .
OBJ_BUCH-302-005.book Page 66 Tuesday, June 9, 2009 2:19 PM