26
| English
1 609 929 S88 | (22.6.09)
Bosch Power Tools
Contact Protector
The contact protector
14
attached to the casing
prevents accidental touching of the saw blade
during the working procedure and may not be
removed.
Sawing Thick Wood
For straight cuts in thick wood, please observe
the following recommendations:
– Switch on Precision Control for lateral guid-
ance of the saw blade (see “Precision Con-
trol”, page 24).
– Use Bosch saw blades marked with “Preci-
sion for Wood”.
– Adjust the precise mitre angle using an angle
measurer.
– Saw applying only low feed. Orbital action
and stroke ensure sufficient working proc-
ess.
– Always guide the machine resting firmly
against the parallel guide
27
or an auxiliary
guide rail. Avoid lateral pressure on the han-
dle
18
to prevent tilting of the machine.
– While sawing, hold the machine with one
hand by the handle
18
and with the other
hand by the plastic cap
1
.
Plunge Cutting (see figures I – J)
f
Plunge cuts may only be applied to soft ma-
terials, such as wood, gypsum plaster
boards, etc.!
Use only short saw blades for plunge cutting.
Plunge cutting is possible only with the mitre an-
gle set at 0°.
Place the machine with the front edge of the
base plate
7
on to the workpiece without the
saw blade
13
touching the workpiece and
switch on. For machines with stroke rate con-
trol, select the maximum stroke rate. Firmly
hold the machine against the workpiece and by
tilting the machine, slowly plunge the saw blade
into the workpiece.
When the base plate
7
fully lays on the work-
piece, continue sawing along the desired cutting
line.
Parallel Guide with Circle Cutter (Accessory)
For cuts using the parallel guide with circle cut-
ter
27
(accessory), the thickness of the material
must not exceed a maximum of 30 mm.
Parallel Cuts (see figure K): Loosen the locking
screw
26
and slide the scale of the parallel guide
through the lead
25
in the base plate. Set the
desired cutting width as the scale value on the
inside edge of the base plate. Tighten the lock-
ing screw
26
.
Circular Cuts (see figure L): Set the locking
screw
26
to the other side of the parallel guide.
Slide the scale of the parallel guide through the
lead
25
in the base plate. Drill a hole in the work-
piece centred in the section to be sawn. Insert
the centring tip
28
through the inside opening of
the parallel guide and into the drilled hole. Set
the radius as the scale value on the inside edge
of the base plate. Tighten the locking screw
26
.
Coolant/Lubricant
When sawing metal, coolant/lubricant should be
applied alongside cutting line because of the
material heating up.
Maintenance and Service
Maintenance and Cleaning
f
Before any work on the machine itself, pull
the mains plug.
f
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the saw blade holder regularly. For this,
remove the saw blade from the machine and
lightly tap out the machine on a level surface.
Heavy contamination of the machine can lead to
malfunctions. Therefore, do not saw materials
that produce a lot of dust from below or over-
head.
OBJ_BUCH-796-003.book Page 26 Monday, June 22, 2009 2:57 PM
