Bosch GSK 64-34 Professional, Оригинальное руководство пользователя

Страница: 11 / 12

1 609 929 X30 | (22.3.11) Bosch Power Tools
20 | English
Maintenance Schedule
Always keep air outlet 4 , discharge lock-off 2 and trigger 5 clean and free
of foreign material (dust, chips, sand, etc).
Clean the magazine 10 . Remove any plastic or wood chips that may accu-
mulate in the magazine during operation.
Clean the pneumatic tool in regular intervals using compressed air.
Correction of Malfunctions
Measure Explanation Action
Draining the exhaust filter daily. Prevents the accumulation of dirt/ debris and
moisture in the pneumatic tool. – Open the drain valve.
Keeping the lubricator filled at all times. Ensures the lubrication of the pneumatic tool. – Fill lubricator with the recommended lubri-
cants.
(See “Lubricating the Pneumatic Tool”,
page 19)
Cleaning the magazine 10 and magazine slider
11 .
Prevents the jamming of nails. – Blow out the mechanism of the
magazine/magazine slider daily with com-
pressed air.
Ensuring that the discharge lock-off 2 functions
properly.
Promotes your work safety and efficient usage of
the pneumatic tool. – Blow out the mechanism of the discharge lock-
off daily with compressed air.
Lubricating the pneumatic tool. Reduces the wear of the pneumatic tool. – Apply 2
–
3 drops of lubricant into air connec-
tor 8 .
(See “Lubricating the Pneumatic Tool”,
page 19)
Draining the compressor. Prevents the accumulation of dirt/ debris and
moisture in the pneumatic tool. – Open the drain valve of the compressor tank.
Problem Cause Corrective Measure
The pneumatic tool is ready for operation
but no nails are discharged. A nail is jammed in the shot duct. – Clear the jam.
(See “Clearing Jams”, page 19)
The magazine slider is 11 defective. – Clean and lubricate the magazine slider 11 as re-
quired and make sure that the magazine 10 is not
dirty/soiled.
The spring of the magazine slider is too week or de-
fective. – Contact an authorised service agent for Bosch
power tools.
Have the component replaced there.
The fasteners being used are not permitted. – Use only original accessories.
Only the fasteners (nails, staples, etc.) specified
in table “Technical Data” may be used.
The magazine 10 is empty. – Refill the magazine.
(See “Loading the Magazine”, page 17)
The nails are discharged very slowly and
with too little pressure. The rated pressure of the compressed-air supply is
too low. – Increase the compressed-air supply. 8 bar may
not be exceeded.
The driver blade is damaged. – Use only the lubricants recommended by Bosch.
(See “Lubricating the Pneumatic Tool”, page 19)
The sealing ring of the piston is worn or damaged. – Contact an authorised service agent for Bosch
power tools.
Have the component replaced there.
The buffer is worn. – Contact an authorised service agent for Bosch
power tools.
Have the component replaced there.
The length and diameter of supply-air hose 15 do not
correspond with the data of this pneumatic tool.
– Use a supply-air hose with the correct dimensions.
(See “Technical Data”, page 16)
The supply-air hose 15 is bent/creased. – Correct the bend/crease in the supply-air hose.
OBJ_BUCH-1302-001.book Page 20 Tuesday, March 22, 2011 11:17 AM