35
Press button
11 [–]
to browse backwards through the saved
values.
If there is no value available in the memory,
“0.000”
is shown
at the bottom of the display and
“0”
at the top.
The oldest value is located in position
1
in the memory, while
the newest value is in position 50 (when 50 memory values are
available). When a further value is saved, the oldest value in
the memory is always deleted.
Deleting the Memory
To delete the content of the memory, press soft key
12 [
]
and
then, as many times as required, press soft key
3 [
]
.
To delete all values stored in the memory, the function can be
used. Confirm by pressing soft key
12 [
]
.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section “Area Measurement”,
see page 30.
2
09.06.2017
13:20:23
0.0º
185 ft
2
2
168 ft
17 ft
+
Press the button
4 [+]
. The calculated area and the
symbol
“+”
will be displayed.
Press the measuring button
2 [ ]
to start another
area measurement. Measure the area as described
in section “Area Measurement”, see page 30. Once
the second measurement is completed, the result
of the second area measurement is displayed below. To show
the end result, press the measurement button
2 [ ]
once more.
Note:
With a length measurement, the end result is displayed
immediately.
Subtracting Values
To subtract values, press button
11 [–]
. The subsequent steps
are the same as for “Adding Values”.
Deleting Measured Values
#SJFGMZ QSFTTJOH UIF 0O0GG$MFBS CVUUPO
9 [ ]
will delete the
last measured value in all measuring functions.
www.
.com
1.800.561.8187
Содержание GLM400CL
Страница 3: ...3 X 1 1 A B www com information itm com 1 800 561 8187 ...
Страница 4: ...4 D X 1 1 C 1 2 X 1 2 www com information itm com 1 800 561 8187 ...
Страница 6: ...6 1 00 2x 2 00 G 1 2 3 1x1 2x1 www com information itm com 1 800 561 8187 ...
Страница 7: ...7 90 180 180 90 180 180º 90º 90º 180º 180º H www com information itm com 1 800 561 8187 ...
